the cables were connected. Leave the cables in the cable management device so that when you
reinstall the cable management device, the cables are organized.
Step 3.
Remove and set aside the cable management devices from the left and right sides of the controller
module.
Step 4.
Squeeze the latch on the cam handle until it releases, open the cam handle fully to release the
controller module from the midplane, and then, using two hands, pull the controller module out of
the chassis.
Step 5.
Turn the controller module over and place it on a flat, stable surface.
Step 6.
Open the cover by sliding in the blue tabs to release the cover, and then swing the cover up and
open.
.
Chapter 5
Hardware replacement procedures
31