• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Atzbq4KHJgYQHkA9FCH0-m
Step 1.
Locate the caching module at the rear of the controller module and remove it.
a.
Press the release tab.
b.
Remove the heatsink.
Step 2.
Gently pull the caching module straight out of the housing.
Step 3.
Insert the new caching module in the controller, and then align the edges of the caching module
with the socket housing and gently push it into the socket.
Step 4.
Verify that the caching module is seated squarely and completely in the socket. If necessary,
remove the caching module and reseat it into the socket.
Step 5.
Reseat and push the heatsink down to engage the locking button on the caching module housing.
Step 6.
Close the controller module cover, as needed.
Installing the controller
After you install the components from the old controller module into the new controller module, you must
install the new controller module into the system chassis and boot the operating system.
About this task
For HA pairs with two controller modules in the same chassis, the sequence in which you install the controller
module is especially important because it attempts to reboot as soon as you completely seat it in the
chassis.
A video for this task is available at:
.
Chapter 5
Hardware replacement procedures
55