Kenwood TH-D74E Service Manual page 26

3.4 Precautions for Reassembly
3.4.1 Mounting of Bluetooth Antenna (BAR SPRING)
(1) Mount the Bluetooth antenna onto the front-side groove of
the case with the absence of the front glass, the state of
which will occur at the time of replacing the front case, for
example.
Bluetooth antenna Bluetooth antenna Bluetooth antenna
(2) Turn the Bluetooth antenna to the rear side of the case, and
mount the antenna onto the rear groove of the case.
3.4.2 Forming of GPS Coaxial Cable
(1) Perform the forming the GPS coaxial cable as shown in the
figure.
1-26 (No.RA044<Rev.001>)
Turn the Bluetooth
antenna to the rear
side of the case.
GPS coaxial cable GPS coaxial cable
3.4.3 Mounting of Top Panel Nuts and Front Case Screws
(1) Assemble the front case into the chassis and attach the two
nuts to the top panel.
(2) Attach the two screws to the front case.
3.4.4 Check on Waterproof Packing of Battery Terminals
and micro SD Card Section
(1) After assembling the TX-RX PCB (TX-RX 2/7) into the
chassis, check that the waterproof packing of the battery
terminal section is firmly inserted.
Battery terminal section Battery terminal section Battery terminal section
waterproof packing waterproof packing waterproof packing
(2) After assembling the front case into the chassis, check
that the waterproof packing of the micro SD card section
is firmly inserted.
micro SD card section micro SD card section micro SD card section
waterproof packing waterproof packing waterproof packing
Waterproof packing NG