Mitsubishi Electric FR-E720-0.1 K Instruction Manual page 272

FR-E500 series operation panel (PA02) setting
Method to adjust any point without turning the potentiometer (changing from 4V(80%) to 5V(100%))
Operation
1.
Perform steps 1. to 4. on page 268, 269.
2.
Set the gain voltage (%).
Analog voltage
value (%) of the
built-in frequency
setting potentiometer
3.
Pressing
4.
Re-set the Pr.79 Operation mode selection value according to the operation mode being used.
Method to adjust only the gain frequency and not to adjust the voltage
1.
Perform steps 1. to 4. on page 268, 269.
2.
Adjust the analog voltage adjustment value.
Analog voltage value (%)
of the built-in frequency
setting potentiometer
3.
Pressing
4.
Re-set the Pr. 79 Operation mode selection value according to the operation mode being used.
Be cautious when setting any value other than "0" as the bias speed at 0V. Even if a speed command is not
given, merely turning ON the start signal will start the motor at the preset frequency.
270
Press the
key once to display
the current analog
voltage calibration value.
Hz RUN
/
A MON MON
PU
shifts to the next parameter.
Operation
Hz RUN
A MON MON
PU
Flicker
shifts to the next parameter.
or Set the gain voltage (%) with
the
[0(%) for 0V (0mA), 100(%) for
5V (10V, 20mA)]
Flicker
Press the or key once to display
the current analog voltage adjustment.
Example:When analog voltage
adjustment value is 100%
Press for 1.5s
SET
CAUTION
/
key.
Press for 1.5s
SET