Mitsubishi Electric FR-E720-0.1 K Instruction Manual page 273

[Setting with the inverter operation panel without fitting the FR-E500 series operation panel (PA02)]
a) Method to adjust any point
(to change to 80% from 100%)
Operation
1.
Confirm the RUN indication and operation mode
indication
The inverter should be at a stop.
The inverter should be in the PU operation mode
(depends on ).
2.
Press to choose the parameter setting
mode.
3.
Turn until
4.
Press until
5.
Turn until
C25 (Pr. 923) Frequency setting voltage gain (built-in
potentiometer)
6.
Press to show the analog voltage value
(%).
7.
Turn to set gain voltage (%).
"minimum value of the potentiometer is 0%,
maximum value is 100%"
REMARKS
The current setting at the instant of turning
8.
Press to set.
Turn
Press
Press
REMARKS
By pressing after step 6, you can confirm the current frequency setting bias/gain setting.
It cannot be confirmed after execution of step 7.
FR-E500 series operation panel (PA02) setting
appears.
appears.
appears.Turn the dial to
to read another parameter.
to return to the indication (step 4).
twice to show the next parameter (
Display
The parameter
number read
previously appears.
C0 to C25 setting
is enabled.
Analog voltage value (%) of built-
Hz Hz
A A
in frequency setting potentiometer
The gain frequency is reached
when analog voltage value
(%) of built-in frequency
setting potentiometer is 80%.
is displayed.
A
Flicker Parameter setting complete!!
(Adjustment completed)
).
4
271