Check and clear of the faults history
(2) Clearing procedure
POINT
Set "1" in Er.CL Fault history clear to clear the faults history.
Operation
1.
Screen at powering ON
The monitor display appears.
2.
Press
to choose the parameter setting mode.
3.
Turn
until
appears.
4.
Press
to read the currently set value. "
value) appears.
5.
Turn
to change it to the set value "
6.
Press
to set.
Turn
Press
Press
Parameters referred to
Pr. 77 Parameter write selection
276
(faults history clear)
" (initial
".
to read another parameter.
to show the setting again.
twice to show the next parameter.
Refer to page 182
PRM indication is lit.
(The parameter number read previously appears.)
Flicker...Faults history clear complete!!
Display