Mounting Instructions - D-Link DCS-5010L User Manual

Section 2 - Installation
To mount your camera on a wall or ceiling, please follow the steps below.
Place the mounting bracket where you want
to position the camera and use a pencil to
mark the points where you will drill the holes.
Depending on the material of the wall or
ceiling, use a 6mm drill bit to drill two holes
where you marked. If the wall is made of
concrete, after drilling the holes, insert the
plastic anchors and then insert the screws.
The power and Ethernet cables can be
concealed behind the mounting bracket.
Run the cables through the back of the
mounting bracket, securing them with the
built-in guides. Be sure to leave enough
cable length protruding from the top to
connect the cables to the camera.
D-Link DCS-5010L User Manual

Mounting Instructions

We suggest that you configure the camera before mounting.
1
2
3
Fasten the mounting bracket to the wall
using the screws provided.
Do not overtighten the screws as this may crack the
mounting bracket.
Using the supplied thumbscrew, fasten the
camera to the mounting bracket. Connect
the power and Ethernet cables to the
camera.
Adjust the angle of the arm on the
mounting bracket as required. Tighten the
thumbscrew to lock the arm in place.
4
5
6
21