Switching The Appliance On/Off And Selecting Intensity - Silvercrest SMGB B1 Operating Instructions Manual

Switching the appliance on/off and selecting intensity
1) Switch the appliance on by moving the main switch 7 on the underside of
the handle 4 to the ON position.
The ring display 5 lights up green.
2) Press the button
The display 2 shows the intensity level
The appliance starts on intensity level
3) To increase the intensity level, press the button
Each press increases the intensity by one level. This is shown on the display 2.
NOTE
► After reaching the highest intensity level, if you press the button
again, the appliance stops working and switches into standby mode.
4) Massage the desired body part by gently moving the attachment back and
forth over the muscle area.
NOTE
► Do not apply too much pressure, otherwise the appliance will automatically
switch off after a few seconds to protect the motor from a possible over-
load.
If this safety device has been triggered,
You need to restart the appliance.
5) After you have finished using the appliance, switch it off by pressing and
holding the button
switch 7 to the OFF position.
NOTE
► The appliance is equipped with an automatic switch-off to prevent over-
heating. The appliance switches off automatically after 15 minutes of
continuous operation. Allow the appliance to cool down for at least
15 minutes before using it again.
│ GB │ IE
■ 12
3 to start the appliance.
.
3 for around 2 seconds and then move the main
.
3 briefly.
will appear on the display 2.
SMGB B1
3