16 Installation
Setting the supply voltage
WARNING!
Selecting the wrong supply voltage may damage or break the encoder.
Two supply voltages are available on pins 4 and 5 in connector X81. Only one of them
can be used to supply an encoder. The supply voltage is selected by placing a jumper
on connector X81 as described in the figure below. The following supply voltages can
be selected:
•
+15 V DC ± 20% 200mA (max.)
•
+24 V DC ± 20% 200mA (max.)
You can also connect an external 10 - 24 V DC power supply to pins 4 and 5 in connector
X81. In that case, the jumper must be removed.
+15 V
Encoder supply voltage available on pins X81-4 and X81-5 with different jumper settings
+24 V
External supply