Supplies And User Maintenance; Td Cartridge Replacement - Sharp AL-800 Operation Manual

5
This chapter describes how to replace the TD cartridge and the drum cartridge.

TD CARTRIDGE REPLACEMENT

The TD cartridge replacement required ( ) indicator will light up when toner is needed. For
information on purchasing TD cartridges, see SUPPLY PART NUMBERS AND STORAGE on
page 44. If copying is continued while the
until the copier stops and the indicator begins blinking. Replace the old TD cartridge by following
the procedure given below.
5
Turn off the copier power.
1
Push gently on both sides of the front cover to open the cover.
2
Release the TD cartridge lock by inserting your fingers into the groove at the center of
3
the handle.
28

SUPPLIES AND USER MAINTENANCE

Be sure to use only genuine SHARP parts and supplies.
When the indicator begins to blink, it may be possible to make a few more
copies by taking the TD cartridge out of the copier, shaking it horizontally, then
reinstalling it. If copying is not possible after this operation, replace the TD
cartridge.
indicator is lit, copies will gradually become lighter