The Set Setting Menu - Sony VPL-SW125 Operating Instructions Manual

The SET SETTING Menu

The SET SETTING menu is used for setting various functions of the projector.
Items
Smart APA
Auto Input Search
Input-A Signal Sel.
Color System
Power Saving Mode
Panel Key Lock
CC Display
*4
Network Setting
IP Address Setup
IP Address/Subnet
Mask/Default
Gateway/DNS
Server/Apply
Lamp Timer Reset
Item descriptions
On/Off: When set to "On," executes APA automatically when a signal
*1 *2
is input.
On/Off: When set to "On," the projector detects input signals in the
following order: Input-A/Input-B/Video/S Video. It indicates the input
channel when the power is turned on or the INPUT key is pressed.
Auto/Computer/Component/Video GBR: When set to "Auto,"
selects the type of video signal input automatically when "Input-A" is
selected with the INPUT key.
Auto/NTSC /PAL/PAL-60/SECAM/NTSC
3.58
When set to "Auto," selects the color system automatically when "S
Video" or "Video" is selected with the INPUT key.
Lamp Cutoff: The lamp turns off automatically and power
consumption is reduced if no signal is input for 10 minutes. The lamp
lights again when a signal is input or any key is pressed. In Lamp
Cutoff, the ?/1 key lights in orange (page 30).
Standby: The power will be turned off automatically and the projector
goes to Standby mode if no signal is input for 10 minutes.
Off: The Power Saving Mode is canceled.
On/Off: When set to "On," locks all the control panel keys of the
projector. However, you can operate the following when set to "On":
• Press and hold the ?/1 key for approximately 10 seconds during
Standby mode.
c The projector turns on.
• Press and hold the ?/1 key for approximately 10 seconds during
power on.
c The projector goes to Standby mode.
• Press and hold the MENU key for approximately 10 seconds during
power on.
c "Panel Key Lock" is set to "Off" and enables operation of all keys
on the projector.
CC1/CC2/CC3/CC4/Text1/Text2/Text3/Text4: Select the closed
caption service (Captions or Text).
Off: Closed caption does not appear.
Auto (DHCP): The IP address is assigned automatically from the
DHCP server such as a router.
Manual: To specify the IP Address manually.
When "Manual" is selected for "IP Address Setup," select the item
with the B or b key and input the value with V or v key. When all
items are entered, select "Apply" then press the ENTER key. The
entered settings will be registered.
When replacing the lamp, resets the lamp timer (page 34).
*3
/PAL-M/PAL-N:
4.43
*3
The SET SETTING Menu
21