Advertisement
20) Fix the cutter drive unit to the printer with the three SM-4x8 screws.
SM-4x8 Screw
Cutter Drive Unit
SM-4x8 Screw
21) Connect the 9-pin connector of the harness ass'y to CN7 and 2-pin connector to CN9 on the cutter
driver unit, respectively.
Harness Ass'y
CN9 (2 pins)
CN7 (9 pins)
22) Fit the bush to the harness ass'y in the orientation as shown below.
Bush
Harness Ass'y
23) Insert the harness ass'y into the hole in the main frame. Fit the bush into the hole.
Main Frame
Hole
Harness Ass'y
- 12 -
Get other manuals https://www.bkmanuals.com
Advertisement
