Advertisement
11) Fix the harness ass'y with the clamp.
12) Connect the 9-pin connector of the harness ass'y to CN15, and 2-pin connector to CN18 on the
Main PC board, respectively.
13) Turn the head lever counterclockwise to Free position.
14) Open the ribbon shaft holder plate.
Head Lever
Lock position
(Tag)
15) Raise the print head block until it stops.
Stopper
CN18 (2 pins)
CN15 (9 pins)
Free position
Lock position
(Label)
Get other manuals https://www.bkmanuals.com
Main PC Board
Harness Ass'y
Ribbon Shaft Holder Plate
Print Head Block
- 4 -
Clamp
Advertisement
