Manually Starting The Package - Pioneer V050-PPI-01 Owner's Manual

Manually Starting the Package

Refer to "Manual Mode Screen Navigation" on page 21
NOTE: Attempting to navigate away from the Manual Mode screen while the pump is in
operation will cause a warning screen to appear. If the YES button is selected on the
warning screen, the pump will be stopped, and navigation will continue. If the NO but-
ton is selected, pump operation will continue, and navigation will be canceled.
1. From the Home screen, press Manual Mode.
2. If not already completed, press the Motor Settings button to set up the motor.
• Refer to "Motor Configuration" on page
• Press Back when finished.
3. Select desired Speed Control Source from the drop-down list.
• Refer to "Speed Control Source" on page
4. Set desired speed using the control source chosen in the previous step.
IMPORTANT: Motor rotation will start in the next step.
5. Press START.
6. Verify the rotation of the motor fan and shaft coupling is correct.
7. If rotation is incorrect, press the FWD/REV button.
• Confirm the selection in the pop-up dialog box.
NOTE: The pump will slow to a stop, change direction, and restart automatically.
8. Adjust speed as required.
• Refer to "Speed Control Source" on page
NOTE: Motor speed will be displayed on the RPM Gauge.
9. Press Sensor Status to monitor any connected analog sensor readings.
• Refer to "Sensor Status Screen" on page
10. Press STOP to turn off the motor and pump.
for details about each button on screen.
13.
22.
22.
29.
OPERATION
Manual Mode
23