Table of Contents
Advertisement
Configuration Options via Command Line (Cont.)
Satellite Receiver Menu Commands
The following subsections describe how to access and use the Satellite Receiver Menu
commands.
Access the Satellite Receiver Menu
1. Access the card menu for the selected transcoder (see "Access the Transcoder Menu" on
page 39).
[HCS7720 (#)] Command > prompt, type stb and press Enter.
2. At the
[Satellite (#)] Command > prompt, either:
3. At the
• Press Enter to display the Satellite Receiver Menu (see example below).
• Type the desired command and press Enter.
Note: You can always press Enter at the
Receiver Menu.
Example: Satellite Receiver Menu
-----------------------
Satellite Receiver Menu
-----------------------
getch
Read Current STB Channel
setch
Set STB Channel
sglvl
Read Satellite Signal Strength
lksts
Read Satellite Lock Status
bnum
Read STB Serial Number
cnum
Read Smart Card Number
on
Turn STB On
off
Turn STB Off (Standby)
stbrst
Reset Satellite STB
getupd
Read STB Update Parameters
setupd
Set STB Update Parameters
model
Read STB Model
ver
Read STB Software Version
ret
Return to Card Menu
[Satellite (#)] Command >
206-4183
Command > prompt to display the Satellite
Get other manuals https://www.bkmanuals.com
where:
# is the chassis card/slot
number you selected for
configuration purposes.
43
Advertisement
Table of Contents
