Installing A Codeplus Feature Card - LG CodePlus HCS6320 Series Installation & Setup Manual Warranty

Slot 5
Slot 1 Slot 2 Slot 3 Slot 4
HCS7720 HCS7720 HCS6400 HCS7720
ASI OUT ASI OUT ASI OUT
HDMI-IN HDMI-IN HDMI-IN
RESET RESET RESET
STATUS STATUS STATUS
SERVICE SERVICE SERVICE
PORT PORT PORT
X PORT LINK X PORT LINK X PORT LINK
S/N XXXXXXX S/N XXXXXXX S/N XXXXXXX
MAC ADDRESS MAC ADDRESS MAC ADDRESS
XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX
Note: The CodePlus series products are NOT
designed to be hot-swappable!!! Power must be
removed to the card frame before any CodePlus
transcoder cards are inserted or removed.
Note: All cards used in the card frame must
be inserted and removed by qualified service
personnel only.
Note: Use extreme care when handling an
HCS6320 card. Always observe proper
precautions with respect to static electricity
and mechanical shock. When not installed in
a card frame, return the HCS6320 card to the
anti-static bag in which it was shipped.
Note: The card slots in the card frame are NOT
all identical!!! An HCS6320 card can only be
installed in the CONTROLLER slot. The
connector arrangement of Slots 1 to 6 and 7 to
12 is incompatible with the HCS6320.
Note: When installing cards, remove blank
cover plates and insert new cards as applicable.
For ports that will not be used, leave the blank
cover plates in place for proper ventilation and
FCC and safety agency compliance.
206-4183

Installing a CodePlus Feature Card

Slot 6
CONTROLLER
Slot
HCS6320
Slot 7 Slot 8
ETHERNET
HCS6720 HCS6400 HCS7720
ASI OUT
SERVICE
PORT
RESET
HDMI-IN
STATUS
RESET
STATUS
SERVICE
PORT
X PORT LINK
RF OUT
S/N XXXXXXX S/N XXXXXXX
MAC ADDRESS MAC ADDRESS
XX XX XX XX XX XX XX XX XX XX
Get other manuals https://www.bkmanuals.com
Slot 9 Slot 10 Slot 11 Slot 12
HCS6400
HCS7720 HCS7720 HCS7720
ASI OUT ASI OUT ASI OUT ASI OUT
HDMI-IN HDMI-IN HDMI-IN
RESET RESET RESET RESET
STATUS
STATUS STATUS STATUS
SERVICE SERVICE SERVICE SERVICE
PORT PORT PORT PORT
X PORT LINK X PORT LINK X PORT LINK X PORT LINK
S/N XXXXXXX
S/N XXXXXXX S/N XXXXXXX
MAC ADDRESS MAC ADDRESS MAC ADDRESS
XX XX XX XX XX
XX XX XX XX XX XX XX XX XX XX
Follow the procedure below to install the
CodePlus feature card.
1. Unpack the HCS6320 unit.
2. Remove the AC power cord for the card
frame from the power outlet.
3. Prepare the CONTROLLER slot in
the card frame by removing either the
blank cover plate or the CodePlus card
currently in the slot.
4. Without using force, slide the HCS6320
card into the CONTROLLER slot, and
ensure that it is fully inserted.
5. Engage and tighten the top and bottom
thumbscrews of the card securely. Note
that the thumbscrews should only be
finger tight; overtightening may damage
the assembly.
6. Refer to the diagram on page 12 for
cable connections, and complete the
HCS6320 system installation procedure
on page 13.
11