Table of Contents
Advertisement
Making ice cubes
Use only drinking water to make ice
cubes.
Fill the ice cube tray with drinking
1.
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
To loosen the ice cubes, twist the
2.
ice cube tray slightly or hold it
briefly under flowing water.
operation
7 Basic operation
operation
7.1 Switching on the appli-
ance
Electrically connect the appliance.
1.
→ Page 11
Note: If the appliance has been
previously switched off using the
control panel, press and hold
for three seconds.
a The appliance begins to cool.
a A warning signal sounds and the
temperature display (freezer com-
partment) and
cause the freezer compartment is
still too warm.
Switch off the warning tone using
2.
.
goes out as soon as the
a
set temperature has been reached.
Set the required temperature.
3.
→ Page 15
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
flash be-
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
Press and hold
▶
three seconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
Press the required temperature.
▶
The recommended temperature in
the refrigerator compartment is
4 °C.
Setting the freezer compartment
temperature
Press the required temperature.
▶
The recommended temperature in
the freezer compartment is
−18 °C.
8 Additional functions
8.1 Super cooling
With Super cooling, the refrigerator
compartment cools as cold as pos-
sible.
Switch on Super cooling before pla-
cing large quantities of food.
operation en
for
15
Advertisement
Table of Contents
