Changing The Hydraulic Fluid And Filter - Toro Groundsmaster 7200 Series Operator's Manual

3. Raise the deck to extend the lift cylinders, shut
off the engine, and remove the key.
4. Raise the seat to access the hydraulic fluid tank.
5. Remove the hydraulic fill cap from the filler neck
(Figure 56).
Figure 56
1. Dipstick
6. Remove the dipstick and wipe it with a clean rag
(Figure 56).
7. Place the dipstick into the filler neck; then
remove it and check the level of fluid
Note:
If the level is not within the notched area
of the dipstick, add enough high-quality hydraulic
fluid to raise the level to within the notched area.
Important:
Do not overfill.
8. Replace the dipstick and thread the fill cap
finger-tight onto the filler neck.
9. Check all hoses and fittings for leaks.
g004494
2. Fill cap
(Figure 56).
Changing the Hydraulic
Fluid And Filter
Service Interval: After the first 200 hours
Every 800 hours
1. Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Place a large pan under the hydraulic reservoir
and transmission case and remove the plugs,
draining all of the hydraulic fluid
1. Hydraulic-reservoir drain
plug
2. Filter
4. Clean the area around the hydraulic fluid filter
and remove the filter
5. Immediately install a new hydraulic fluid filter.
6. Install the hydraulic-reservoir and
transmission-case drain plugs.
7. Fill the reservoir to the proper level
(approximately 5.7 L or 6 US qt); refer to
Checking the Hydraulic System (page
8. Start the engine and check for oil leaks. Allow
the engine to run for about 5 minutes, then shut
it off.
9. After 2 minutes, check the level of the hydraulic
fluid; refer to Checking the Hydraulic System
(page 50).
51
- position, and
EUTRAL LOCK
position,
LOW
(Figure
Figure 57
3. Transmission-case drain
plug
(Figure 57).
57).
g004652
50).