Adjusting The Hopper Door; Adjusting The Locking-Pin Stop On The Mower Deck - Toro 74312 Operator's Manual

Adjusting the Hopper Door

1. Stop the machine and move the speed-control
lever to the N
EUTRAL
2. Disengage the PTO, engage the parking brake,
shut off the engine, and wait for all moving parts
to stop.
3. Loosen the 6 door hinge nuts
4. Open the door and place a 3/8 inch (9.5 mm)
rubber strip or 3/8 inch (9.5 mm) diameter hose
between the hopper and the hopper door
58).
5. Close the door and push it tight against the
hopper.
6. Tighten the hinge hardware.
7. Open the hopper door and remove the rubber
strip.
Figure 58
1. Loosen the door hinge
nuts—3 per side.
position.
(Figure 58).
(Figure
2. Place a piece of 9.5 mm
(3/8 inch) rubber on this
surface.
Adjusting the Locking-Pin
Stop on the Mower Deck
1. Slide the mower-deck locking pins in on both
sides of the mower deck and rotate them to lock
the mower deck in the operation position.
2. Loosen the jam nut and turn the stop screw
clockwise until the locking pin is tight and cannot
be rotated by hand
1. Rotate the stop screw clockwise until the locking pin is tight,
then back off 1/2 turn.
2. Loosen the jam nut.
3. Loosen the stop screw counter clockwise 1/2
turn and tighten the jam nut.
4. Test the locking pin to make sure that it slides
freely. Adjust it if necessary.
g025251
52
(Figure 59).
Figure 59
g007581