After Use - Silvercrest SDM 1500 C2 Operating Instructions Manual

9) Wipe over the desired area .
If the water tank 8 becomes empty during use:
NOTE
► Once the water tank 8 has been pumped empty, the pump will continue
running a little while until the empty water tank 8 is indicated by the simul-
taneous flashing of the red control lamp "high steam level" q, the green
control lamp "low steam level" w and POWER control lamp 0 .
–
Press the "Steam" button r again to stop steam production .
–
Set the on/off switch u to "O" .
–
Remove the water tank 8, fill it and replace the water tank 8 as
described in the section "Filling with water" .
–
Set the on/off switch u to "I" .
–
Select the desired steam level as described above and press the
"Steam" button r .
10) When you are finished treating all of the surfaces, press the "Steam"
button r to stop steam production .
11) Set the on/off switch u to "O" . The POWER control lamp 0 goes out .
12) Remove the power plug from the mains power socket .
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may
be due to the previously used cleaning fluids . Simply clean the floor again
using the steam mop . The smears should now be gone .

After use

1) Allow the appliance to cool down .
2) Remove the pad 6 .
3) Remove the water tank 8 from the appliance and empty it .
4) Pull the upper cable hook z out a little and turn it back upwards .
Wind the cable back around the two cable hooks z/i .
Fix the end of the power cable using the cable clip located on the cable .
SDM 1500 C2 GB │ MT │ 47 ■