Table of Contents
Advertisement
8-3
"Model Name and ECA Parameter Setting"
Model Name is automatically acquired at scanning.
When the data was collected normally, Model Name is Displayed at "Acquired Name" and "ECA Name" of
the main screen.
When the data could not be collected normally, Model name is displayed in red. In this case, set Model
Name individually, using this screen.
When parameter value is required for the electricity charge apportionment, "Required" is shown in the
"ECA Param" column of the main screen.
When shown, open this screen and enter the value.
When "Acquired" is shown, there will be no field to enter in this screen.
*
Model name and parameter setting is not required for S/V series.
Select the menu items in order of "Setting"→"Model Name and ECA Parameter Setting" from the Menu bar.
Select "Model Name".
For the outdoor unit or indoor unit
without any RB unit connected.
Note
Some units have more than 2 sets of ECA parameter.
For such units, model name is suffixed with index number in brackets to distinguish a particular set of
ECA parameter.
For detail of the index number, refer to the description in the "ReadMe.txt" file within the installation DVD.
When ECA parameter field is displayed
Enter the value in the corresponding field.
External Fan Rated Power Consumption: Enter the rated power consumption of the external fan used
with DX-Kit.
Click the "OK" button.
Copyright© 2010-2017 Fujitsu General Limited. All rights reserved.
For the indoor unit with RB unit connected
56
Advertisement
Table of Contents
