Lubrication; Greasing The Bearings And Bushings - Toro 30602 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2) (Figure 37)
•
Front and rear axle pivot bushings (2) (Figure 38)
•
Steering cylinder ball joints (2) (Figure 39)
•
Tie rod ball joints (2) (Figure 39)
•
King pin bushings (2) (Figure 39).
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 37
Figure 38
Center Cutting Unit
Note: Deck may have to be raised to expose the grease
fittings for the latch pivot and the lower link.
Latch pivot (2) (Figure 41)
Note: The latch (Figure 40) may need to be manually tripped
to gain access to the grease fitting. Use a prybar to close and
re-open the latch
1. Latch
38
Figure 39
Figure 40