Table of Contents
Advertisement
Drive System
Maintenance
Adjusting the Traction Pedal
Angle
The traction pedal operating angle can be adjusted for
operator comfort.
1. Loosen the two nuts and bolts securing the left side of
the traction pedal to the bracket (Figure 61).
Figure 61
1. Traction pedal
2. Pivot the pedal to the desired operating angle and
tighten the nuts (Figure 61)˙.
Changing the Planetary Gear
Drive Oil
Service Interval: After the first 200 hours
Every 800 hours (Or yearly, whichever comes first)
Change the oil initially after first 200 hours of operation.
Thereafter change the oil every 800 hours, or yearly, whichever
occurs first. Use a high quality SAE 85W-140 gear lube.
1. With the machine on a level surface, position a wheel
so that one of the check plugs is at the lowest (6
o'clock) position (Figure 62).
2. Mounting nuts and bolts
(2)
1. Check/drain plug
2. Place a drain pan under the planetary hub, remove plug
and allow oil to drain.
3. Place a drain pan under the brake housing, remove the
drain plug and allow the oil to drain (Figure 42).
1. Drain plug
4. When all of the oil has drained from both locations,
re-install the plug in the brake housing.
5. Rotate the wheel until the open plug hole in the
planetary is at the twelve o'clock position.
6. Through the open hole, slowly fill the planetary with
0.5 liter (22 ounces) of high quality SAE 85W-140 wt.
gear lube.
Important: If the planetary fills before the 0.5 liter
(22 ounces) of oil is added, wait one hour or install
the plug and move the machine approximately ten
feet to distribute the oil through the brake system.
Then, remove the plug and add the remaining oil.
7. Re-install the plug.
8. Repeat the procedure on the opposite planetary/brake
assembly.
45
Figure 62
g020680
Figure 63
2. Brake housing
Advertisement
Table of Contents
