Adjusting The Mirrors; Aiming The Headlights; Starting And Stopping The Engine - Toro 30602 Operator's Manual

Figure 30
1. Front castor arm
2. Shims
Matching Height Of Cut Between Cutting Units
1. Position blade side to side on outside spindle of both
side cutting units. Measure from the floor to the tip of
the cutting edge on both units and compare. These
numbers should be within 3 mm (1/8 inch) of each
other.
2. Add or remove 1/8 inch shims as needed on wing
castor wheels. Recheck measurement between outside
edges of both wing cutting units and adjust as necessary

Adjusting the Mirrors

Cab model only
Rear View Mirror
While sitting in the seat, adjust the rear view mirror
(Figure 31) to attain the best view out the rear window. Pull
the lever rearward to tilt the mirror to reduce the brightness
and glare of light.
Side View Mirrors
While sitting in the seat, have a helper adjust the side view
mirrors (Figure 31) to attain the best view around the side of
the machine.
3. Front castor fork
1. Side view mirrors
2. Rear view mirror

Aiming the Headlights

1. Loosen the mounting nuts and position each headlight
so that it points straight ahead. Tighten the mounting
nut just enough to hold the headlight in position.
2. Place a flat piece of sheet metal over the face of the
headlight.
3. Mount a magnetic protractor onto the plate. While
holding the assembly in place, carefully tilt the headlight
downward 3 degrees, then tighten the nut.
4. Repeat the procedure on the other headlight.
Starting and Stopping the
Engine
Important: The fuel system will automatically bleed
itself when any of the following situations occur:
•
Initial start up of a new machine.
•
The engine has ceased running due to lack of fuel.
•
Maintenance has been performed upon the fuel system
components.
1. Ensure that the parking brake is set. Remove your foot
from the traction pedal and ensure that it is in neutral.
2. Turn the ignition key to the Run position.
3. When the glow indicator dims, turn the ignition key
to the Start position. Release the key immediately
when the engine starts and allow it to return to the
Run position. Allow engine to warm up at mid speed
(without load), then move the throttle control to the
desired position.
Important: Do not run the starter motor more
than 30 seconds at a time or premature starter
failure may result. If the engine fails to start
after 30 seconds, turn the key to the Off position,
recheck the controls and procedures, wait 30
additional seconds, and repeat the starting
procedure.
31
Figure 31
3. Lever