Adjusting The Mirrors - Toro 30606 Operator's Manual

5. Check for bent blades; refer to Checking for a
Bent Blade.
6. Cut grass in a test area to determine if all cutting
units are cutting at the same height.
7. If cutting unit adjustments are still needed, find a
flat surface using a 2 m (6 foot) or longer straight
edge.
8. To ease measuring blade plane, raise the height
of cut to 7.6 to 10.1 cm (3 to 4 inches); refer to
Adjusting the Height of Cut.
9. Lower cutting units onto the flat surface.
Remove the covers from the top of the cutting
units.
10. Loosen the flange nut, securing the idler pulley,
to release the belt tension on each cutting unit.
Front Cutting Unit Setup
Rotate blade on each spindle until the ends face
forward and backward. Measure from the floor to the
front tip of the cutting edge. Adjust 3 mm (1/8 inch)
shims on front castor fork(s) to match height of cut to
decal (Figure 30); refer to Adjusting the Cutting Unit
Pitch.
Figure 30
1. Tensioning cap
2. Spacers
3. Shims
Side Cutting Unit Setup
Rotate blade of each spindle until the ends face
forward and backward. Measure from the floor to the
front tip of the cutting edge. Adjust 3 mm (1/8 inch)
shims on front castor arm(s) to match height of cut to
decal (Figure 31). For the outside blade spindle only,
refer to Adjusting the Cutting Unit Pitch.
g008866
4. Top axle mounting hole
5. Castor wheel
1. Front castor arm
2. Shims
Matching Height Of Cut Between Cutting Units
1. Position blade side to side on outside spindle of
both side cutting units. Measure from the floor
to the tip of the cutting edge on both units and
compare. These numbers should be within 3
mm (1/8 inch) of each other.
2. Add or remove 1/8 inch shims as needed on
wing castor wheels. Recheck measurement
between outside edges of both wing cutting
units and adjust as necessary

Adjusting the Mirrors

Cab model only
Rear View Mirror
While sitting in the seat, adjust the rear view mirror
(Figure 32) to attain the best view out the rear window.
Pull the lever rearward to tilt the mirror to reduce the
brightness and glare of light.
Side View Mirrors
While sitting in the seat, have a helper adjust the side
view mirrors (Figure
the side of the machine.
33
Figure 31
3. Front castor fork
32) to attain the best view around
g011561