Lubrication; Greasing The Bearings And Bushings - Toro 30606 Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
The machine has grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If the machine is operated
under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should
only be lubricated annually (2 pumps).
Figure 60
Figure 61
(Figure
(Figure
(Figure 62)
(Figure 62)
(Figure 62).
60)
61)
Center Cutting Unit
Note:
Deck may have to be raised to expose the
grease fittings for the latch pivot and the lower link.
Latch pivot (2)
Note:
The latch
tripped to gain access to the grease fitting. Use a
prybar to close and re-open the latch
g009246
1. Latch
g004687
50
Figure 62
(Figure 64)
(Figure 63) may need to be manually
Figure 63
g011499
g009440