Toro 30606 Operator's Manual page 30

spindle shaft to get the desired height-of-cut;
then slide the washer onto the shaft.
Refer to the following chart to determine the
combinations of spacers for the setting:
Figure 19
4. Push the castor spindle through the front castor
arm. Install the shims (as they were originally
installed) and the remaining spacers onto the
spindle shaft. Install the tensioning cap to
secure the assembly.
5. Remove the hairpin cotter and clevis pin
securing the height-of-cut chains to the rear of
the cutting unit (Figure
Figure 20
1. Height-of-cut chain
6. Mount the height-of-cut chains to the desired
height-of-cut hole
and hairpin cotter.
20).
2. Clevis pin and hair pin
cotter
(Figure 21) with the clevis pin
Note:
decal100-5622nc
(1-1/2 inch), or occasionally 51 mm (2 inch)
height-of-cut, move the skids and gage wheels
to the highest position.
Wing Cutting Units
To adjust the height-of-cut on the side cutting units,
add or remove an equal number of spacers from the
castor forks, position the castor wheel axles in the
high or low height-of-cut holes in the castor forks, and
secure the pivot arms to the selected height-of-cut
bracket holes.
1. Position the castor wheel axles in the same
holes in all of the castor forks
Figure
determine the correct hole for the setting.
2. Remove the tensioning cap from the spindle
shaft
castor arm. Put the two shims (3 mm [1/8
inch]) onto spindle shaft as they were originally
installed. These shims are required to achieve
a level across the entire width of the cutting
units. Slide the appropriate number of 13 mm
(1/2 inch) spacers onto the spindle shaft to get
the desired height-of-cut; then slide the washer
onto the shaft.
g020968
30
Figure 21
When using 25 mm (1 inch), 38 mm
24). Refer to the following chart to
(Figure 22) and slide the spindle out of
decal106-4251nc
(Figure 22 and