Toro 30606 Operator's Manual page 31

Figure 22
1. Tensioning cap
2. Spacers
3. Shims
Refer to the following chart to determine the
combinations of spacers for the setting.
Figure 23
3. Push the castor spindle through the castor arm.
Install the shims (as originally installed) and the
remaining spacers onto the spindle shaft. Install
the tensioning cap to secure the assembly.
4. Remove the hairpin cotter and clevis pins from
the castor pivot arms
5. Rotate tension rod to raise or lower pivot arm
until holes are aligned with selected height-of-cut
bracket holes in the cutting unit frame
24 and Figure 25).
6. Insert the clevis pins and install the hairpin
cotters.
7. Rotate tension rod counterclockwise (finger
tight) to put tension on adjustment.
4. To axle mounting hole
5. Castor wheel
decal100-5622nc
(Figure 24).
(Figure
g008866
1. Castor pivot arm
2. Axle mounting holes
Adjusting the Skids
The skids should be mounted in the lower position
when operating at heights of cut greater than 64
mm (2-1/2 inches) and in the higher position when
operating at heights of cut lower than 64 mm (2-1/2
inches).
Adjust the skids by removing the flange bolt and
nuts, positioning them as desired, and installing the
fasteners (Figure 24).
31
Figure 24
3. Clevis pin and hair pin
cotter
4. Tension rod
Figure 25
g004676
decal100-5623nc