Toro 30606 Operator's Manual page 27

Fuel Tank Capacity
79 L (21 US gallons)
Adding Fuel
1. Park the machine on a level surface.
2. Using a clean rag, clean area around fuel tank
cap.
3. Remove cap from the fuel tank
Figure 13
1. Fuel tank cap
4. Fill the tank until the level is to the bottom of the
filler neck with diesel fuel.
5. Install fuel tank cap tightly after filling tank.
Note:
If possible, fill the fuel tank after each
use. This will minimize possible buildup of
condensation inside the fuel tank.
Checking the Hydraulic Fluid
Service Interval: Before each use or daily
The machines reservoir is filled at the factory with
approximately 29.3 liters (7.75 U.S. gallons) of
high quality hydraulic fluid. Check the level of the
hydraulic fluid before the engine is first started
and daily thereafter. The recommended replacement
fluid is:
(Figure 13).
Toro Premium All Season Hydraulic Fluid
(Available in 18.9 liter (5 gallon) pails or 208 liter (55
gallon) drums. See parts catalog or Toro distributor for
part numbers.)
Alternate fluids: If the Toro fluid is not available, other
fluids may be used provided they meet all the following
material properties and industry specifications. We
do not recommend the use of synthetic fluid. Consult
with your lubricant distributor to identify a satisfactory
product.
Note:
caused by improper substitutions, so use only
g020448
products from reputable manufacturers who will stand
behind their recommendation.
High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG 46
Material Properties:
Industry Specifications:
Note:
making it difficult to spot leaks. A red dye additive for
the hydraulic system oil is available in 20 ml (2/3 oz)
bottles. One bottle is sufficient for 15-22 liters (4-6
gallons ) of hydraulic oil. Order part no. 44-2500 from
your authorized Toro distributor.
1.
2.
3.
27
Toro will not assume responsibility for damage
Viscosity, ASTM D445
Viscosity Index ASTM D2270
Pour Point, ASTM D97
Many hydraulic fluids are almost colorless,
Position the machine on a level surface, lower
the cutting units, stop the engine, and remove
the key.
Unlatch the seat, raise it, and engage the prop
rod.
Clean the area around the filler neck and cap of
the hydraulic tank (Figure
from the filler neck.
St @ 40° C 44 to 50
St @ 100° C 7.9 to 8.5
140 to 160
-34° F to -49° F
Vickers I-286-S (Quality
Level), Vickers M-2950-S
(Quality Level), Denison
HF-0
14). Remove the cap