Table of Contents
Advertisement
•
Perform a recovery-regeneration whenever
there is a loss of engine power and a parked
regeneration cannot effectively clean the DPF of
soot.
•
A recovery regeneration requires up to 4 hours
to complete.
•
You need a distributor technician to perform the
recovery regeneration process; contact your
Authorized Toro Distributor.
Smart Power
With Toro Smart Power™, the operator does not have
to listen to the engine speed in heavy conditions.
Smart Power prevents bogging down in heavy turf
by automatically controlling the machine speed and
optimizing cutting performance. The operator can
simply set a max ground speed that is comfortable,
and mow without having to manually reduce the
traction speed when mowing in heavy conditions.
Reversing Fan Operation
The fan speed is controlled by hydraulic oil
temperature and engine coolant temperature. A
reverse cycle is automatically initiated when either the
engine coolant or hydraulic oil temperature reaches
a certain point. This reversal will help blow debris off
the rear screen and lower the engine and hydraulic
oil temperatures. By simultaneously pressing the
right and left buttons on the InfoCenter, the fan will
complete a manually initiated reverse cycle. It is
recommended to manually reverse the fan prior to
transporting on roads, entering the shop or a storage
area.
Auto Idle
The machine is equipped with auto idle which
automatically idles the engine when all of the following
functions are not used, for a pre determined time,
previously set in the InfoCenter.
•
The traction pedal is returned to the neutral
position
•
The PTO is disengaged
•
None of the lift switches are activated
When any of the above functions are initiated, the
machine will automatically return to the previous
throttle position.
Cruise Control
The cruise control switch locks in the pedal position to
maintain the desired ground speed. Pressing the rear
of the switch turns off the cruise control, the middle
position of the switch enables the cruise control
function and the front of the switch sets the desired
ground speed
Note:
Pressing either brake pedal or moving the
traction pedal into the reverse position, for one
second, will also disengage the cruise control
Engine Speed Switch
The engine speed switch has two modes to change
the engine speed. By momentarily tapping the switch,
the engine speed can be increased or decreased in
100 rpm increments. By holding the switch down the
engine will automatically move to High or Low idle,
depending on which of the switch is depressed.
Mow Speed
Supervisor (Protected Menu)
Allows the supervisor to set the machine's maximum
mowing speed, in increments of 50%, 75% or 100%,
at which the operator can mow (low range).
Refer to Using the InfoCenter LCD Display, in the
Operation section of this manual, for the procedure to
set the mow speed.
Operator
Allows the operator to adjust the machine's maximum
mowing speed (low range), within the supervisors
pre-adjusted settings. When in the InfoCenter splash
or main screen, press the middle button (
to adjust the speed.
Note:
When switching between low and high ranges,
the settings will transfer based on the previous setting.
The settings are reset when the machine is turned off.
Note:
This feature may also be used in conjunction
with cruise control.
Transport Speed
Supervisor (Protected Menu)
Allows the supervisor to set the machine's maximum
transport speed, in increments of 50%, 75% or 100%,
at which the operator can transport (high range).
Refer to Using the InfoCenter LCD Display, in the
Operation section of this manual, for the procedure to
set the transport speed.
Operator
Allows the operator to adjust the machine's maximum
transport speed (high range), within the supervisors
pre-adjusted settings. When in the InfoCenter splash
or main screen, press the middle button (
to adjust the speed.
43
icon)
icon)
Advertisement
Table of Contents
