2.6
2.5" SATA Drive Installation
Before installing the SATA Drive, ensure the system is powered down and disconnect
the power cord from the system. Make sure you have the SATA Drive ready to install.
See Chapter 1 for SATA drive specifications for compatibility.
Step 1: If you have not already done so, remove the six (6) screws from the bottom of
the BOXER-6617-ADN as shown in the figure below. Remove the bottom panel from
the system.
Step 2: Attach the SATA drive to the HDD Bracket using the screws provided.
Chapter 2 – Hardware Information
38