2.6
2.5" SATA Drive Installation
Before installing the SATA Drive, ensure the system is powered down and disconnect
the power cord from the system. Make sure you have the SATA Drive ready to install.
Step 1: Remove the four (4) screws from the bottom of the chassis to remove the
bottom panel from the system.
Step 2: Attach the SATA drive to the HDD Bracket using the screws provided.
Step 3: Attach the HDD Bracket to the bottom panel using four screws as shown in the
figure below. Attach the SATA and SATA Power cables to the board and the SATA drive.
Chapter 2 – Hardware Information
33