Table of Contents
Advertisement
2.5
DDR4 SODIMM Installation
Before installing the DDR4 module, ensure the system is powered down and
disconnect the power cord from the system. Make sure you have the module ready to
install.
Step 1: Remove the four (4) screws from the bottom of the chassis as shown, then
remove the bottom panel from the system.
Step 2: Insert the DDR4 module into the slot, followed by a thermal pad both on top of
and underneath the DIMM heatsink. Note the diagram below for correct placement of
each thermal pad.
Chapter 2 – Hardware Information
32
Advertisement
Table of Contents
