Overview; Specification - Toshiba TOSVERT VF-S15 Function Manual

2. Overview

This product is a dual port PROFINET communication module that can be used in a PROFINET Industrial
Ethernet. This product also offers an embedded Web server which offers comfortable monitoring and
setup directly from a standard web browser.

2.1. Specification

Module specifications
Item
Type-form
Applicable inverter
Connector
Supported network
Indicator
Protection degree
Environments
Network specifications
Item
Baud rate
Cyclic communication
Acyclic communication
PROFINET
Configuration
IP configuration mode
PROFINET IO classes
I&M
Response time
Baud rate
Modbus TCP Supported function
IP configuration mode
MRP
LLDP
Ethernet
Web server
*Response time is the time until the inverter is operated by RUN command on the cyclic communication
Specification
PNE001Z
VF-S15 CPU1 Ver.112 or later (With SBP009Z)
VF-AS3
VF-MB1 CPU1 Ver.116 or later
Dual RJ45 shielded connector
PROFINET, Modbus TCP
4 LEDs indicating the communication status and error
status.
IP20
Correspond to inverter.
Note) The maximum ambient temperature for VF-AS3 is 50
degrees when the option is installed.
Specification
100Mbps (Full duplex)
PROFIdrive V.4.1 (Telegram1)
4PKW and 2 PZD vendor format (Telegram100)
4PKW and 6 PZD vendor format (Telegram101)
6 PZD vendor format (Telegram102)
Reading the PROFIdrive parameter
Reading/writing the inverter parameters
Configure by PROFINET master
Manual setup, DCP, DHCP, Embedded Web server
Conformance Class-B
I&M function 0
*Cyclic communication About 11ms on VF-AS3
Cyclic communication About 14ms on VF-S15/MB1
10/100Mbps (Full/Half duplex)
Read Holding Registers (03H)
Write Single Register (06H)
Write Multiple Registers (10H)
Read Device Identification (2BH)
Manual setup, DHCP, Embedded Web server
Supported
Supported
Inverter status monitor, inverter parameter
monitor/configuration, Network status monitor,
password lock
- 7 -
E6582051