Toro Groundsmaster 360 Operator's Manual page 38

Note: To access the grease fittings for the rear-steering
linkage, remove the storage compartment.
Note: Raise the machine off the floor with a jack and secure
it with jack stands to allow better grease migration through
Note: The bearing life can be negatively affected by
improper washing procedures. Do not wash the machine
when it is still hot and avoid directing high-pressure or
high-volume spray at the bearings or seals.
both the upper and lower king-pin bushings. You should see
grease purging out of both the top and the bottom of the axle
casting/bushing assembly areas of all 4 kingpin assemblies
(Figure 34).
Figure 33
38
G026734
g026734