Cab Maintenance; Filling The Washer-Fluid Bottle; Cleaning The Cab Air Filters - Toro Groundsmaster 360 Operator's Manual

Figure 53
1. Transmission-case-drain
plug
2. Filter
4. Clean the area around the hydraulic-fluid filter and
remove it (Figure 53).
5. Immediately install a new hydraulic-fluid filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level (approximately 17
L or 18 US qt); refer to
(page 50).
8. Start the engine and check for leaks. Allow the engine
to run for about 5 minutes, then shut it off.
9. After 2 minutes, check the level of the hydraulic fluid;
refer to Checking the Hydraulic System (page
3. Hydraulic-reservoir-drain
plug
Checking the Hydraulic System
50).

Cab Maintenance

Filling the Washer-Fluid Bottle

1. Perform the pre-maintenance procedure; refer to
Preparing the Machine for Maintenance (page
2. Open the hood and locate the washer-fluid bottle
(Figure 54).
g014393
Washer-Fluid Bottle with Washer-Fluid Symbol
3. Fill the bottle with washer fluid as needed.
4. Close the hood.

Cleaning the Cab Air Filters

Service Interval: Every 250 hours Replace the cab air filters
1. Remove the screws and grates from over both the
in-cab and rear cab air filters
51
Figure 54
if they are torn or excessively dirty.
(Figure 55).
36).
g028438