Cab Maintenance; Cleaning The Cab; Cleaning The Cab Air Filters; Cleaning The Cab-Condenser Filter - Toro 31900A Operator's Manual

Cab Maintenance

Cleaning the Cab

Important:
Use care around the cab seals
86). If you are using a pressure washer, keep the
washer wand at least 0.6 m (2 ft) away from the
machine. Do not use the pressure washer directly
on the cab seals or under the rear overhang.
Figure 86
1. Seal
2. Keep wand 0.6 m (2 ft)
away.

Cleaning the Cab Air Filters

Service Interval: Every 400 hours
1. Remove the knobs and grates from the cab rear
overhang (Figure
3. Do not pressure wash
under the rear overhang.
87).
(Figure
1. Filter
2. Knob
2. Remove the air filters from the cab.
3. Clean the filters by blowing clean, oil-free,
compressed air through them.
Important:
other damage, replace the filter.
4. Use the knobs and grates to install the filters
into the cab
Cleaning the
Cab-Condenser Filter
The purpose of the cab-condenser filter is to prevent
large debris, such as grass and leaves, from entering
the cab condenser and condenser fans.
1. Pull the screen cover straight down.
2. Clean the condenser filter with water.
g034330
Note:
Important:
other damage, replace the filter.
3. Allow the filter to dry before installing it into the
machine.
4. Rotate the filter screen around the tabs until
the latch locks into the latch-mount assembly
(Figure
72
Figure 87
3. Grate
If either filter has a hole, tear, or
(Figure 87).
Do not use a pressure washer.
If the filter has a hole, tear, or
88).
g251432