Toro 31900A Operator's Manual page 44

WARNING
If you leave the key in the switch, someone
could accidently start the engine and
seriously injure you or bystanders.
Remove the key from the switch and do not
start the engine with the cutting unit in the
S position.
ERVICE
1. Park the machine a level surface.
2. Press the lift switch to raise the cutting unit to
the T position.
RANSPORT
3. Engage the parking brake, shut off the engine,
and remove the key.
4. Remove the pins from the height-of-cut plates
(Figure 38).
Figure 38
1. Height-of-cut pins
5. Rotate the cutting unit
latch engages with the tie-down bracket
40).
WARNING
The cutting unit is heavy.
Use assistance when you lift the cutting
unit.
g258474
2. Height-of-cut plates
(Figure 39) so that the
(Figure
Rotating the Cutting Unit to the
T Position
RANSPORT
Perform this procedure to rotate the cutting unit from
the S position to the T
ERVICE
1. Release the cutting-unit latch from the tie-down
bracket (Figure
slightly forward (refer to
the latch handle forward.
44
Figure 39
Figure 40
position.
RANSPORT
41) by rotating the cutting unit
Figure 39) and pulling
g298275
g298276