Table of Contents
Advertisement
Figure 9
1. Manifold
2. Port C1
C.
Use a drift punch to align the cylinder rod
holes with the lift-arm holes
Note:
Fully raise the lift arm to help with
the alignment.
Figure 10
1. Cylinder rod
2. Small pin
D.
Use 2 bolts (3/8 x 1-1/4 inches), 2 nuts (3/8
inch), and 2 small pins to secure the lift
arms to the cylinders
E.
Torque the hose swivel nut on port C1 to
41 N∙m (30 ft-lb).
Note:
Use a backup wrench to prevent the
hose from twisting.
6.
Grease the attachment pin joints and lift-arm
pin joints; refer to
Bushings (page
51).
3. Hose swivel nut
(Figure
10).
3. Nut (3/8 inch)
4. Bolt (3/8 x 1-1/4 inches)
(Figure
10).
Greasing the Bearings and
5
Installing the Front Tires
Models 31900A, 31901A, and
31907A Only
No Parts Required
Procedure
g312025
1.
Use the previously-removed lug nuts to secure
the tires to the wheel hubs
1. Wheel hub
2. Tire
2.
Torque the wheel lug nuts; refer to
Wheel-Lug Nuts (page
g467781
15
(Figure
11).
Figure 11
3. Lug nut
Torquing the
62).
g299550
Advertisement
Table of Contents
