Removing The Front Tires - Toro 31900A Operator's Manual

3. Install each tire as follows:
•
2-wheel-drive machines:
A. Apply thread-locking compound to the
bolt (5/8 x 1-1/4 inch).
B. Use a small washer, large washer, bolt
(5/8 x 1-1/4 inch), and to secure the
wheel to the axle spindle
Figure 3
1. Axle spindle
2. Tire
3. Small washer
4. Large washer
C. Torque the bolt to 203 N∙m (150 ft-lb).
D. Install the dust cap to the wheel
3).
•
4-wheel-drive machines: Use 4 lug nuts to
secure the wheel to the wheel hub
Figure 4
1. Wheel hub
2. Tire
(Figure 3).
g312833
5. Bolt (5/8 x 1-1/4 inch)
6. Dust cap
7. Apply thread-locking
compound to the bolt.
(Figure
(Figure
g299549
3. Lug nut
4. Torque the wheel lug nuts; refer to
Wheel-Lug Nuts (page
3

Removing the Front Tires

Models 31900A, 31901A, and
31907A Only
No Parts Required
Procedure
Note:
You must perform this procedure to correctly
install the lift arms.
1. Loosen and remove the wheel lug nuts
11).
4).
1. Wheel hub
2. Tire
2. Removed the wheels from the wheel hubs
(Figure 11).
13
Torquing the
62).
Figure 5
3. Lug nut
(Figure
g299550