Installing The Bumper - Toro 31900A Operator's Manual

10

Installing the Bumper

Models 31900A, 31901A, and
31907A Only
Parts needed for this procedure:
1 Bumper
2 Bolt (3/8 x 3 inches)
4 Bolt (3/8 x 3-1/4 inches)
6 Nut (3/8 inch)
Procedure
1. Remove the bumper from the shipping skid.
2. Loosely secure the upper area of the bumper
to the machine frame using 4 bolts (3/8 x 3-1/4
inches) and 4 nuts (3/8 inch) as shown in
15.
Figure
1. Bolt (3/8 x 3-1/4 inches)
2. Bumper
3. Loosely secure the bumper under the machine
frame using 2 bolts (3/8 x 3 inches) and 2 nuts
(3/8 inch) as shown in
4. Tighten the hardware.
18
Figure 15
3. Bolt (3/8 x 3 inches)
Figure 15.
g302775