4
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the hydraulic-fluid level before starting the
engine, refer to
Checking the Hydraulic System (page
50).
2. Check the engine-oil level before starting the engine,
refer to
Checking the Engine-Oil Level (page
3. Check the cooling system before starting the engine;
refer to
Checking the Cooling System (page
5
Adjusting the Roll Bar
Models with Roll Bar Only
No Parts Required
Procedure
Important: Always use the seat belt when the roll bar
is in the raised and locked position. Do not use the seat
belt when the roll bar is in the lowered position.
1. Remove the hairpin cotters and the pins from the roll
bar
(Figure
5).
2. Raise the roll bar to the upright position and install the
2 pins and secure them with the hairpin cotters
5).
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins so
that it does not damage the hood.
39).
1. Roll bar
2. Pin
45).
(Figure
14
Figure 5
3. Hairpin cotter
g014166