Table of Contents
Advertisement
2-3. Performance
For measurement tolerances, operating tolerances and other data, refer to the instruction manual for the
ultrasound diagnostic instrument.
2-4. Name of each parts
Scanner tip
This area is held during operation.
Ultrasonic irradiation area
This incorporates an electronic
convex transducer.
Caution
Do not pull, bend, twist, or apply excessive force to the cable.
The conductors may break and the cable may become unusable.
Do not subject the ultrasonic irradiation area to hard impact.
The impact may cause damage to the transducer, and that results in noise or no echo in the image.
In most cases, the ultrasonic irradiation area itself is not damaged because the part is made of plastic
material.
Front mark
This protrusion indicates the direction
of the front mark (direction mark) on
the image display
Cable
This cable propagates the ultrasonic signals
that are sent and received.
Connector
This is the part that connects the
ultrasound diagnostic instrument and
scanner. Follow the instructions in
section 4-2.
-11-
MN1-5933 Rev.5
Advertisement
Table of Contents
