Table of Contents
Advertisement
STS-(3000K, 6000K)-H1 Smart Transformer Station
(Spain, Eiffage Turroneros)
Installation Guide
Paint Damage
Logo and pattern
damage
Dent
Procedure
Step 1 Gently polish the damaged areas using fine sandpaper to remove smudges or rust.
Figure A-1 Polishing a damaged area using sandpaper
Step 2 Dip a piece of cotton cloth into anhydrous alcohol and wipe the polished or damaged area to
remove the dirt and dust. Then wipe off the alcohol with a clean and dry cotton cloth.
Issue 02 (2020-02-21)
Tools and
Materials
sandpaper,
anhydrous alcohol,
cotton cloth,
painting gun
(required for
repainting a large
area)
If a logo or pattern is damaged, provide the
logo size and color number. Seek help from
the local advertisement coating supplier to
formulate a repair solution based on the
logo size, color, and damage.
1. If a dent is less than 100 mm
less than 3 mm in depth, fill the dent
with Poly-Putty base and then perform
the same operations as those for
processing deep scratches.
2. If a dent is greater than 100 mm
or greater than 3 mm in depth, ask the
local supplier for an appropriate
repainting solution.
Copyright © Huawei Technologies Co., Ltd.
Procedure
2
in area and
2
in area
A FAQ
Description
scratches or
large-area
smudges and
rust, use a
painting gun to
spray paint.
4. The paint coating
should be thin
and even. Paint
drops are
prohibited on the
coating. The
surface should be
smooth.
5. Leave the
repainted area for
about 30 minutes
before
performing any
further operation.
69
Advertisement
Table of Contents
