Beko BM33U Instructions For Installation And Operation Manual page 22

Inspection and maintenance
Pos: 68 /Beko Technische Dokumentation/Sicherheit/Hinweis Vorschriften Werkzeug Reinigung Kondensat Entsorgung @ 0\mod_1233239666823_2901.docx @ 13340 @ @ 1
Note:
It is imperative to observe all hazard statements and warnings listed here.
Please also observe all regulations and notes regarding industrial safety and fire prevention at the place
of installation.
As a matter of principle, only use suitable and appropriate tools and materials in a proper condition.
Do not use aggressive cleaners and improper devices such as high-pressure cleaners.
Please note that condensates may contain aggressive or harmful components. Therefore, skin contact
should be avoided.
Condensate is subject to mandatory waste disposal. As such, it must be collected in suitable containers,
and disposed of or processed properly.
Pos: 69 /Beko Technische Dokumentation/Wartung/BEKOMAT/Wartung BM 33U (nicht Vario+IF) 2x8760h @ 6\mod_1375358388906_2901.docx @ 32983 @ @ 1
22
Maintenance recommendation:
After 2 x 8,760 operating hours or one million
switching cycles, a maintenance message is released.
The green power LED flashes. Afterwards, or at
the latest after two years (2 x 8,760 operating hours),
the service unit (5) needs to be replaced.
1. Prior to the replacement of the service unit,
a reset needs to be carried out. The control unit
is released by actuating the arresting hook. When
removed, the TEST button below the LED must
be pressed and held for at least five seconds.
It is recommended to clean the condensate receiver
tank after two years at the latest, when maintenance
works are carried out:
2. Remove the control unit (1) by
pressing the arresting hook (23).
3. BEKOMAT
outlet.
1
4. BEKOMAT
tubing at the inlet.
5. Unscrew both M6 cross recessed head screws
(22) and remove the service unit (9)
by slightly pulling and lifting it.
23
6. Remove the design shell (11)
using a screwdriver.
7. Unscrew the four cover screws (16)
and remove the cover (17).
8. Clean the condensate receiver tank (19).
® 33U / 33U CO Unfasten from the
®
33U / 33U CODetach from the
BEKOMAT® 33U / 33U CO