Advertisement
HP 11757B
frequencies for the notch. Press
STRT FRQ, then use the arrow or data keys to set a
value in MHz (use 50 for this example), then press
. The display should show
4 ENTER 5
Press
and set a value using data or arrow
4 ENTER 5
keys (95 for this example), then press
4. The next two items displayed are \
and \
4 STOP RATE
for S-Curve measurements and will be ignored when
making M-Curve measurements. Press
display reads \
5 ERROR BITS
5.
determines the number of errors that
ERROR BITS
are counted before a nal bit error rate calculation is
made. You may enter powers of 2 from 2 to 15 (4 ,
8, . .. , 32768). Press
arrow key to get 2
485
.
4 ENTER 5
6. The next displayed item is \
and use the
arrow key to select between the three
485
options:
MIN, NON-MIN and BOTH
displayed, press
4 ENTER 5
7. The Fader will then display \
indicates the decision criteria for drawing an
M-Curve. Press
4 ENTER 5
to toggle through the options: ALARM, 1E-3, 3E-4,
1E-4, 3E-5, 1E-5 and 1E-6. Unless you have opted to
use the ALARM INPUT to make the measurement,
select one of the other criteria and press
8. The display will then read \
parameter determines the peak frequency per second
at which the notch oscillations will take place for
Dynamic M-Curve measurements. Press
access. Speed is entered in megahertz per second.
The PRESET is 300 MHz per second. Use the
arrow key to toggle between the allowable values: 10,
Digital Radio Testing
to access
4 ENTER 5
2 STOP FRQ
4 ENTER 5
3 START RATE
". These parameters are used
until the
495
".
to access and use the
4 ENTER 5
, which equals 2048. Press
11
". Press
PHASE
. When both is
.
", which
CRITERIA
and use the
arrow key
485
4 ENTER 5
". This
8 SPEED
4 ENTER 5
.
.
"
4 ENTER 5
.
to
495
1-15
Advertisement
