Advertisement
Digital Radio Testing
Measurement
Printing Results
1-24
8. The display will then read \
parameter determines the peak frequency per second
at which the notch oscillations will take place for
Dynamic M-Curve measurements. It does not apply
to S-Curve Measurements. Press
9. The display will now read \
applies only to Dynamic M-Curve Measurements.
Press
.
495
10. The display should then read \
This feature is not useful for S-Curve measurements
and will be ignored. Press
11. The display will now read \
This feature is not available for Dynamic S-Curve
measurements.
12. The display will now read \
This feature is not available for Dynamic S-Curve
measurements. The measurement setup is now
complete.
You are now ready to make the actual measurement.
Press
. The display will indicate that the
4 MEAS 5
measurement is in progress. When the measurement
has nished, the display will return to normal. If you
press the
4 PRESET/LOCAL 5
during the measurement, the measurement will be
interrupted and stop.
1. After the measurement has been completed, you can
print the results. First, set the printer destination.
Press
4 SHIFT 5 4 MEAS 5
arrow key to select between
Press
on
4 ENTER 5
1 DEST
Use
to select between
485
Press
on
4 ENTER 5
INTERN
internal thermal printer.
". This
8 SPEED
.
495
9 DEVIATION
10 EDGE ZOOM
.
495
11 MK SEARCH
12 DFM TYPE
key on the Fader front panel
(PRINTER), then use the
and
1 DEST
2 PRINT
to set the destination.
and
EXTERN
INTERN
to set the printout for the
HP 11757B
". This
".
".
".
485
.
.
Advertisement
