(3)After the terminal board connection, pull the cable a little so that the cable runs straight from the terminal
board without unnecessary winding. However, if the sheath-removed part goes as far as where the packing
is located, air may leave through there and the airtight structure may not function. See the incorrect
example in Figure 5.7. Then tighten the cable gland with a wrench.
○
Correct
○
Incorrect
(4) Attach the terminal box cover . To keep the seal, tighten securely the cover.
Figure 5.7 Cabling Procedure
− 35 −
6F8A0882