Advertisement
Notice in operation:
SEAL DUCT layer on the back side of COVER DUCT PC As. has 1 sticky side. Avoid
deforming SEAL DUCT in operation. Air guide installation will be stucked if SEAL DUCT is
front side
6.5 Disassemble BARRIER PF AS.
Take out all the upper and
bottom tray of BARRIER PF
AS.
BARRIER PF AS. front side and back side
6.6 Disassemble COVER DUMPER PC AS.
Position of COVER
DUMPER PC AS.
back side
Air guide installation
screw position
Take out 4 screw above and
at the bottom as in the picture.
screw position
Remove 2 screws
10
SEAL DUCT
Pull out BARRIER PF AS by
two hands at once as show in the
SENSOR PFC and PCC then
take COVER DUMPER PC AS.
fingure. .
Undo 2 connectors of
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
