Setting Up The Hp 103140; Introduction; Duplicating The Master Disk - HP 10314D User Manual

1
Setting Up the HP 103140
Introduction
Duplicating the
Master Disk
HP 103140
The HP 10314D Preprocessor Interface, when installed in the
HP 10269C General Purpose Probe Interface, provides a complete
interface between an 80386DX target system and the following
HP logic analyzers: HP 1650A, HP 1650B, HP 1652B, HP 16510A,
HP 16510B, HP 16511B, HP 16550A, and an HP 16540A,D with two
HP 16541A,D expansion cards. The preprocessor interface connects
the signals from the 80386DX target microprocessor to the logic
analyzer inputs and generates all status and clock signals required by
the software for inverse assembly of the 80386DX instruction set.
The 80386DX Preprocessor Interface operates in the bus mode. In the
bus mode all bus cycles, including prefetches, are sent to the logic
analyzer as they occur. All coprocessor cycles on the local bus are also
captured.
The 80386DX configuration software on the flexible disk sets up the
format specification of the logic analyzer for compatibility with the
80386DX microprocessor. It also loads the inverse assembler routine
for obtaining displays of 80386DX data in assembly language
mnemonics.
The preprocessor interface can be used for timing analysis as well as
state analysis. The State!Timing switch on the preprocessor interface
board determines which type analysis is obtained. In the Timing
position, a minimal amount of skew is added between the signals.
Before you use the HP 10314D software, use the Duplicate Disk
operation in the disk menu of your logic analyzer to make a duplicate
copy of the HP 10314D master disk. Store the master
disk
and use the
back-up copy to configure your logic analyzer. This will help prevent
the possibility of losing or destroying the original files in the event the
disk wears out, is damaged, or a file is accidentally deleted.
80386DX Preprocessor Interface
Setting Up the HP 103140
1-1